Skil 9215 Bedienungsanleitung PDF herunterladen (Seite 8)

BLADE STORAGE COMPARTMENT

Your tool is equipped with a blade storage

compartment (Fig. 6) on the backside of your

saw. To remove, push down on tab and slide

in direction of arrow. Be sure storage

compartment is closed to prevent blades from

falling out.

1. Securely clamp the work.

2. Mark the line of cut and grasp the tool with

one hand on the handle and the other

placed on the insulated rubber boot over

the front housing.

Always hold the saw by the

insulated boot on the front

housing. If you saw into a blind area where

live wiring exists, you may be shocked or

electrocuted.

3. Keep the saw footplate firmly against the

work to minimize counter-force (jumping)

and vibration.

4. Squeeze the trigger to start the tool. Let the

saw reach full speed before starting the cut.

Guide the saw so that the blade will move

along the marked line.

SAWING TIPS

Following a few simple tips will reduce the

wear on the workpiece, the tool and the

operator.

1. Blades cut on the draw or back stroke. On

fine work, such as paneling, fiberglass, etc.,

place the good side of workpiece facing

down.

2.

Use the correct saw blade for the material

being cut and keep extra blades on hand to

use when others become dull. Replace

cracked or bent blades immediately.

3. Select the footplate projection settings, as

well as the appropriate cutting speed.

4. To reduce the risk of injury, be sure the

blade always extends beyond the footplate

and work throughout the stroke. Blades

FOOTPLATE ADJUSTMENT

The footplate tilts in order to keep as much of

i

ts surface in contact with the work surface

F

ig. 4 . To adjust, hold saw firmly and pivot

footplate to desired position.

T

he footplate can also be locked at desired

d

epths to optimize blade life and/or to limit

blade protrusion beyond the end of the

footplate when cutting into large diameter pipe

or into walls.

To adjust the footplate position depth, simply

loosen the two screws in insulated rubber boot

with wrench provided, slide and move the

f

ootplate to the desired position and securely

t

ighten the screw with the wrench provided

(Fig. 5).

Using the Saw

!

WARNING

FIG. 6

BLADE

STORAGE

TAB

BLADE STORAGE

COMPARTMENT

-8-

FOOTPLATE

FIG. 4

FIG. 5

SM 2610001755 07-08 7/14/08 9:41 AM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare